Sor Single Point Ultrasonic Level Switch Instrukcja Użytkownika Pobierz pdf (Strona 2)

2/12

Form 712 (05.13) ©SOR Inc.

PC Board Arrangement

Sensor Installation (Applies to all models)

Series 701 Ultrasonic Level Sensors can be mounted by inserting the sensor through a

fitting in a vessel, or the sensor may be suspended over an open sump or basin. Keep the

sensor cavity out of the direct flow of liquid fill to prevent false readings. Install a baffle to

divert liquid flow if necessary.

DO NOT weld any part of this instrument.

9 Position Terminal Block (Reverse Side)

 Ground (Earth)

 Power Supply

 DPDT Level Indication

Relay Contact

Failsafe Slide Switch

(optional)

Sensor Lead Connection

Replaceable Fuse(s)

Power LED

Wrench Flat

No Obstructions

Housing Hub

Apply thread sealant

Tank or Vessel

Make sure that the sensor can be fully inserted and tightened without interference from

obstructions inside the tank or vessel.

Apply suitable sealant to the process

connection to prevent process leakage.

Use an open end wrench to tighten

the sensor into the process connection.

Do not use the sensor housing as a

handle to tighten the process connection.

1 2 3 4 5 6 7 ... 11 12

Brak uwag

Sor Single Point Ultrasonic Level Switch Instrukcja Użytkownika Strona 2